Toshiba Satellite R10 Maintenance Manual page 225

3.32 SETUP
8. I/O ports
(b) Parallel
This option sets the interrupt request level and I/O port base address for the parallel
port. When the parallel port mode is set to Std. Bi-direct, the options are as
follows:
LPT setting
LPT 1
LPT 2
LPT 3
Not Used
When the parallel port mode (see settings below) is set to ECP, the DMA channel
can also be set to 1 or 3. The default is 3.
LPT setting
LPT 1
LPT 2
LPT 3
Not Used
When you select one of the above options, except for Not Used, a subwindow
similar to the one below appears to let you set the DMA. The options for this setting
are Channel 1and Channel 3 (Default).
For most printers, the port should be set to ECP. With some other parallel devices,
the setting should be Std. Bi-Direct.
9. Drives I/O
This option displays the address and interrupt level for hard disk drive and optical disk
drive. It is for information only and cannot be changed.
Built-in HDD
Select Bay
3-106
Interrupt level
7
5
7
Interrupt level
7
5
7
OPTIONS
DMA = Channel 3 (Default)
This item cannot be changed.
This item cannot be changed.
3 Tests and Diagnostics
I/O address
378H
278H
3BCH
Disables port
I/O address DMA channel
378H 3 (Default)
278H 3
3BCH 3
Disables port
Satellite R10 Maintenance Manual (960-504)