Connecting Printer To Computer Or Network - Fuji Xerox DocuPrint M218 fw User Manual

 Connecting Printer to Computer or Network
Connect the printer via Ethernet or USB. Hardware and cabling requirements vary for the different
connection methods. Ethernet cable and hardware are not included with your printer and must be
purchased separately.
The available features for each connection type are shown in the following table.
• DocuPrint M218 fw
Connection Type
USB
Ethernet
USB Connection
If your printer is attached to a network instead of your computer, skip this section and go to
Connection" on page
To attach the printer to a computer:
1
Ensure that the printer, computer, and any other attached devices are turned off and unplugged
from the power source/outlet.
2
Connect one end of a USB cable into the USB port at the rear of the printer, and the other end to
a USB port of the computer.
NOTE:
• Do not connect the printer USB cable to the USB connector available on the keyboard.
Available Features
When connected via USB you can:
• Instruct print jobs from a computer.
• Scan and print an image into an application.
• Scan and print an image to a folder on the computer.
• Use the Address Book Editor to manage Address Book entries.
When connected via Ethernet you can:
• Instruct print jobs from a computer on the network.
• Scan and print an image to a computer on the network.
• Scan and print an image to an FTP server.
• Scan to email.
• Use CentreWare Internet Services to manage Address Book
entries.
69.
USB port
Printer Connection and Software Installation
"Network
68