Valves And Cylinder Head Components; Valves And Cylinder Head Removal And Installation - Suzuki 2006 SX4 Service Manual

1D-35 Engine Mechanical:

Valves and Cylinder Head Components

1. Cylinder block
2. Cylinder head
3. Cylinder head gasket
: Identification number provided on gasket comes
to crankshaft pully side, facing up.
4. Intake valve
5. Exhaust valve
6. Valve spring seat
Valves and Cylinder Head Removal and
Installation
Removal
1) Remove camshafts, tappets and shims. Refer to
"Camshafts, Tappet and Shim Removal and
Installation" for removal.
7. Valve stem seal
8. Valve spring
9. Valve spring retainer
10. Valve cotter
11. Valve guide
12. Cylinder head bolt (M10)
2) Loosen cylinder head bolts in such order as
numbered in figure and remove them.
S6RW0C1406028
NOTE
Don't forget to remove cylinder head bolt
(M6) (3) as shown in figure.
"5"
1
"4"
1. Crankshaft pulley side
13. Cylinder head bolt (M6)
: Be sure to tighten cylinder head bolt (M6) after securing
cylinder head bolt (M10).
14. Knock pin
: Tighten 52 N⋅m (5.2 kgf-m, 38.0 lb-ft), 82 N⋅m (8.2 kgf-m, 59.5
lb-ft), 0 N⋅m (0 kgf-m, 0 lb-ft), 52 N⋅m (5.2 kgf-m, 38.0 lb-ft)
and 103 N⋅m (10.3 kgf-m, 74.5 lb-ft) by the specified
procedure.
: 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
: Do not reuse.
: Apply engine oil to sliding surface of each part.
"9" "11"
3, "1" "8" "10"
2. Flywheel side
S6RW0C1406027
I5JB0A142039-01
"7" "3"
2
"6" "2"
I5JB0A142040-02