Suzuki 2006 SX4 Service Manual page 483

b) Install snap ring using snap ring pliers.
c) Apply grease to oil seal lip, install oil seal (2) to
coupling case (1) using special tool as shown in
figure.
NOTE
Install oil seal horizontally to surface of
coupling case.
"A": Grease 99000–25010 (SUZUKI Super
Grease A)
Distance between case and oil seal "a"
: 1.5 – 2.5 mm (0.06 – 0.10 in.)
Special tool
(A): 09913–75810
(A)
28) Install spacer (1) to coupling assembly (2) as shown
in figure.
2
1
29) Install grommet of coupling harness into groove of
coupling case and then install coupling assembly by
using hydraulic press.
30) Install companion flange to pinion, and then hold
companion flange with special tool and tighten flange
nut.
Tightening torque
Flange nut: 110 N·m (11.0 kgf-m, 79.5 lb-ft)
Special tool
(A): 09930–40113
2, "A"
"a"
1
1
I5RW0A320060-02
2
1
I5RW0A320065-01
31) Clean mating surface of differential carrier (1) and
coupling case (2), apply sealant to carrier as shown
in figure by such amount that its section is 1.5 mm
(0.059 in.) in diameter, mate coupling case with
differential carrier as shown in figure, and then
tighten bolts to specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Coupling case bolt (a): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
NOTE
Install coupling pin (3) by fitting it to groove
(4) of coupling case.
2
3
(a)
Differential: 3B-45
(A)
I5RW0A320061-01
"A"
4
1
I5RW0A320062-04