Suzuki 2006 SX4 Service Manual page 416

2C-9 Rear Suspension:
3) Connect wheel speed sensor (3) and tighten wheel
speed sensor bolt (2WD model) to specified torque.
Tightening torque
Wheel speed sensor bolt (b): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
[A]
1
2
[B]
(a)
(b)
[A]: 4WD model
[B]: 2WD model
Tightening Torque Specifications
Fastening part
Wheel nut
Rear shock absorber upper nut
Rear shock absorber lower nut
Rear axle bolt
Brake pipe flare nut
Rear wheel hub mounting bolt
Wheel speed sensor bolt
NOTE
The specified tightening torque is also described in the following.
"Rear Suspension Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
3
(a)
2
3
I7RW01230015-02
Specifications
4) Install rear brake disc and rear brake caliper
assembly referring to "Rear Brake Disc Removal and
Installation in Section 4C".
5) Install rear drive shaft (4WD model) referring to
"Rear Drive Shaft Assembly Removal and
Installation in Section 3A".
CAUTION
!
• Never reuse rear drive shaft nut.
• Be careful not to damage the rear drive
shaft nut while caulking it. If it is damaged,
replace it with new one.
6) Install wheel and tighten wheel nuts to specified
torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
7) Upon completion of installation, perform brake test.
Rear Suspension Fasteners Inspection
Check each bolt and nut fastening suspension parts for
tightness. Tighten loose one, if any, to specified torque
referring to the figure in "Rear Suspension
Components".
Tightening torque
N⋅m kgf-m
85 8.5
30 3.0
90 9.0
73 7.3
16 1.6
73 7.3
11 1.1
S6RW0C2306014
S6RW0C2307001
Note
lb-ft
61.5 / / /
22.0
65.0 / /
53.0 /
11.5
53.0
8.0
/