Specifications - Suzuki 2006 SX4 Service Manual

1E-11 Engine Lubrication System:
Radial Clearance
Check radial clearance between outer rotor (2) and case
No.1 (1), using thickness gauge (4).
If clearance exceeds its limit, replace oil pump assembly.
Limit on radial clearance between outer rotor and
case
0.20 mm (0.0079 in.)
3. Inner rotor
Tightening Torque Specifications
Fastening part
Oil pressure switch
Engine oil drain plug
Oil filter
Oil pump strainer bolt
Oil pan bolt and nut
Transmission case No.1 bolt
Oil drain plug
Clutch housing plate upper bolt
Clutch housing plate lower bolt
Oil pump mounting bolt (M8 bolt)
Baffle plate bolt (M6 bolt)
Oil pump chain guide nut
Oil pump sprocket cover bolt
Oil pump relief valve retainer
Oil pump case bolt
NOTE
The specified tightening torque is also described in the following.
"Oil Pan and Oil Pump Strainer Components"
"Oil Pump Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Side Clearance
Using straightedge (5) and thickness gauge (4),
measure side clearance.
If side clearance exceeds its limit, replace oil pump
assembly.
Limit on side clearance
0.11 mm (0.0043 in.)
1. Oil pump case No.1
2. Outer rotor
I2RH01150024-01

Specifications

Tightening torque
N⋅m kgf-m
13 1.3
35 3.5
14 N⋅m (1.4 kgf-m, 10.5 lb-ft) for reference
11 1.1
11 1.1
55 5.5
35 3.5
30 3.0
11 1.1
25 2.5
11 1.1
11 1.1
11 1.1
28 2.8
12 1.2
I2RH01150025-01
3. Inner rotor
S6RW0C1507001
Note
lb-ft
9.5
25.5
8.0
8.0
40.0
25.5
22.0
8.0
18.0
8.0
8.0
8.0
20.5
9.0