Suzuki 2006 SX4 Service Manual page 267

3) Check all around cylinder head for any other parts
required to be removed or disconnected and remove
or disconnect whatever necessary.
4) Remove cylinder head with intake manifold, exhaust
manifold and water outlet cap. Use lifting device, if
necessary.
Installation
1) Match match mark (1) on crank timing sprocket and
mating surface (2) of cylinder block and lower
crankcase.
2) Clean mating surface of cylinder head and cylinder
block (2). Remove oil, old gasket and dust from
mating surface.
3) Install knock pins (3) to cylinder block.
4) Install new cylinder head gasket (1) to cylinder block.
Identification number (6) provided on gasket comes
to crankshaft pulley side (4), facing up (toward
cylinder head side).
5. Flywheel side
5) Install cylinder head to cylinder block.
Apply engine oil to cylinder head bolts and tighten
them gradually as follows.
a) Tighten cylinder head bolts (M10) to 52 N⋅m (5.2
kgf-m, 38.0 lb-ft) according to numerical order in
figure.
b) In the same manner as in step a), retighten
cylinder head bolts (M10) to 82 N⋅m (8.2 kgf-m,
59.5 lb-ft).
"7"
1
"9"
1. Crankshaft pulley side
I2RH01140118-01
c) Loosen cylinder head bolts (M10) until tightening
torque is reduced to 0 according to numerical
order in figure.
"4"
1
"3"
1. Crankshaft pulley side
I5JB0A142041-01
Engine Mechanical:
"5" "1" "3"
"4" "2" "6"
2. Flywheel side
"8" "10" "6"
"7" "9" "5"
2. Flywheel side
1D-36
"10"
2
"8"
I5JB0A142042-01
"2"
2
"1"
I5JB0A142043-01