Suzuki 2006 SX4 Service Manual page 395

13) Remove circlip from knuckle.
14) Using hydraulic press (1) and special tool, remove
wheel bearing.
Special tool
(A): 09913–75510
(B): 09943–37910
15) Remove wheel bearing outside inner race (1).
Special tool
(A): 09913–65810
(B): 09913–85230
16) Remove hub bolts (1) with copper hammer or
hydraulic press.
CAUTION
!
Never remove bolt unless replacement is
necessary.
Be sure to use a new bolt for replacement.
Installation
For installation, reverse removal procedure, noting the
following instructions.
1) Face grooved rubber seal side (1) of new wheel
bearing (2) upward as shown in figure and press-fit it
into knuckle (3) using special tool.
I5RW0A220014-01
Special tool
(A): 09913–75510
(B): 09944–78220
(C): 09925–14520
CAUTION
!
Never reuse wheel bearing.
2) Install circlip (1).
I7RW01220005-01
Front Suspension:
1
I7RW01220006-01
I5RW0A220016-01
4. Encoder
I2RH01220037-01
2B-10