Output Shaft Speed Sensor Inspection; Input Shaft Speed Sensor Removal And Installation; Input Shaft Speed Sensor Inspection; Transmission Fluid Temperature Sensor Removal And Installation - Suzuki 2006 SX4 Service Manual

Output Shaft Speed Sensor Inspection

1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor connector (2).
3) Check resistance between output shaft speed
sensor (1) terminals. If check result is not as
specified, replace sensor.
Output shaft speed sensor resistance
Standard: 344 – 516 Ω at 20 °C (68 °F)
2
1
Input Shaft Speed Sensor Removal and
Installation
Removal
1) Remove battery and battery tray.
2) Disconnect input shaft speed sensor connector (2).
3) Remove input shaft speed sensor (1) by removing its
bolt.
3
3. Transmission range sensor
Installation
1) Apply A/T fluid to new input shaft speed sensor O-
ring.
2) Install input shaft speed sensor (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
3) Connect input shaft speed sensor connector (2) to
S6RW0C5106016 input shaft speed sensor (1).
3
3. Transmission range sensor
4) Install battery tray and battery.

Input Shaft Speed Sensor Inspection

1) Disconnect negative cable at battery.
I4RH01510030-01
2) Disconnect input shaft speed sensor connector (2).
3) Check resistance between input shaft speed sensor
(1) terminals. If check result is not as specified,
S6RW0C5106017
replace sensor.
Input shaft speed sensor resistance
Standard: 344 – 516 Ω at 20 °C (68 °F)
2
1
Transmission Fluid Temperature Sensor
I7RW01510037-01
Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect transmission fluid temperature sensor
connector (1).
Automatic Transmission/Transaxle:
2
1
1
5A-75
2
1
(a)
I7RW01510038-02
S6RW0C5106018
I4RH01510033-01
S6RW0C5106019
I7RW01510039-01