Suzuki 2006 SX4 Service Manual page 403

Installation
1) Install stabilizer bar (1), stabilizer bushing (2) and
stabilizer mounting bracket (3) to front suspension
frame as shown in figure while ensuring that
stabilizer is centered, side-to-side.
NOTE
• For proper installing direction of stabilizer
mounting bracket (3), place oblong to rear
and circular hole to front.
• For correct installation of stabilizer bar,
side-to-side, be sure that stopper ring (4)
on stabilizer bar aligns with mounting
bush, both right and left, as shown in
figure.
2) Tighten stabilizer bar mounting bracket bolts to
specified torque.
NOTE
Tighten stabilizer bar mounting bracket rear
bolt (5) after front bolt (6).
Tightening torque
Stabilizer bar mounting bracket bolt (a): Tighten
23 N⋅m (2.3 kgf-m, 17.0 lb-ft) to specified
procedure
6,(a)
4
2
5,(a)
1
F
3
I5RW0A220029-02
3) Install steering gear case assembly to front
suspension frame referring to "Steering Gear Case
Assembly Removal and Installation in Section 6C" or
"Steering Gear Case Assembly Removal and
Installation in Section 6C".
4) Support front suspension frame (2) with mission jack
(1) and jack up it.
5) Align lugs (1) (right and left) of front suspension
frame with whole (2) in vehicle body.
Front Suspension: 2B-18
2
1
I4RS0A220042-01
2
1
I5RW0A220030-01