AT&T TL86103 User Manual page 88

Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. There are a few ways to begin a PTT call to a single handset. When the
telephone base is not in use:
• If you have one handset, press and hold PTT.
• If you have more than one handset:
w Press PTT, and then use the dialing keys to enter the destination
handset number.
-OR-
w Press Press CID, DIR, /RECORD, or /DELETE to highlight the destination
handset number, and then press
The telephone base shows Connecting to HANDSET X... (HANDSET
represents the handset name, X represents the destination handset number)
for a few seconds. When the connection is made, both the telephone base
and destination handset display Press and hold [PTT] to talk.
2. Press and hold PTT. A chirp indicates your microphone is on. Speak towards
the telephone base. Your voice is broadcast to the destination handset.
While you are speaking, the telephone base shows PTT To HANDSET X.
3. Release PTT after speaking. Both devices beep once again and the screens
show Press and hold [PTT] to talk, and then you can press and hold PTT to
continue speaking or the destination device can respond (see Answer a
PTT call on page 84).
4. To end the PTT call, press CANCEL or
Push to talk Ended for a few seconds.
NOTE: After PTT is released, the PTT call remains open for a short time. If no one presses
PTT within 10 seconds, the PTT call ends automatically.
SELECT or PTT.
END . The telephone base shows
82