Bedbar Assembly - Toro Reelmaster 7000 Service Manual

Bedbar Assembly

5
4
RIGHT
FRONT
1. Bedbar
2. Bedknife
3. Screw
4. Bedbar adjuster shaft (2 used)
5. Flange bushing (4 used)
6. Cap screw (2 used)
7. Detent (2 used)
Bedbar Removal (Fig. 22)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the cutting unit from the machine (see Cut-
ting Unit Removal and Installation in this section).
3. Position cutting unit on work bench. Use the cutting
unit kickstand to support the cutting unit (see Special
Tools).
4. Loosen the lock nuts (item 13) on the end of each
bedbar adjuster assembly until washer (item 11) is loose
on bedbar.
DPA Cutting Units
12
6
10
7
5
9
8
8. Wave washer (2 used)
9. Retaining ring (2 used)
10. Bedbar adjuster screw (2 used)
11. Washer (2 used)
12. Compression spring (2 used)
13. Lock nut (2 used)
Page 8 - - 18
13
11
1
3
2
Figure 22
5. Loosen the lock nuts (item 19) on each bedbar pivot
bolt (item 18).
6. Remove two (2) bedbar pivot bolts (item 18), two (2)
metal washers (item 17) and four (4) plastic washers
(item 16) from the cutting unit side plates.
Contact with the reel, bedknife or other cutting
unit parts can result in personal injury. Use
heavy gloves when handling the bedbar.
7. Remove bedbar assembly from cutting unit.
27 to 33 ft- -lb
(37 to 44 N- -m)
Antiseize
Lubricant
14
16
15
16
Antiseize
Lubricant
14. Rubber bushing (2 used)
15. Flange bushing (2 used)
16. Plastic washer (4 used)
17. Metal washer (2 used)
18. Bedbar pivot bolt (2 used)
19. Lock nut (2 used)
CAUTION
Reelmaster 7000
17
18
19