Adjustments; Adjustments; Mow/Transport Sensor; Component Testing 5 - Toro Reelmaster 7000 Service Manual

Adjustments

Mow/Transport Sensor

The mow/transport sensor is a normally open proximity
sensor that closes when the mow speed limiter is placed
2
in the transport position. The sensor mounts to a bracket
on the footrest platform (Fig. 12). The sensing plate for
the mow/transport sensor is a tab on the mow speed lim-
iter.
Adjustment
1. The gap between the mow/transport sensor and the
mow speed limiter should be from 0.040" to 0.100" (1.1
to 2.5 mm).
1
2. If gap is incorrect, loosen jam nuts that secure sensor
to footrest platform. Position switch with jam nuts to al-
low correct gap between sensor and mow speed limiter.
Figure 12
Tighten jam nuts to secure adjustment. Jam nuts should
be torqued from 162 to 198 in- -lb (18.4 to 22.4 N- -m).
1. Mow/transport sensor 2. Mow speed limiter
After jam nuts are tightened, make sure that clearance
between head of mow/transport sensor and the mow
speed limiter has not changed.
3. After adjustment to the mow/transport sensor, use
the Diagnostic Display (see Special Tools in this chap-
ter) to verify that mow/transport sensor and circuit wiring
are functioning correctly (see Mow/Transport Sensor in
the Component Testing section of this chapter).
Reelmaster 7000 Page 5 - - 15 Electrical System