Toro Reelmaster 7000 Service Manual page 303

5. Check alignment of pulleys with a straight edge
placed along the outer face of the driven pulley (Fig. 48).
The outer faces of the driven and drive pulleys (not the
idler pulley) should be in line within 0.030" (0.76 mm). If
necessary to align pulleys, remove driven pulley from
brush shaft and add or remove hardened washer(s)
(item 9) until drive and driven pulleys are aligned within
0.030" (0.76 mm).
6. Check that roller brush is parallel to rear roller with
0.060" (1.5 mm) clearance to light contact with roller
(Fig. 49). If contact is incorrect, brush operation will be
adversely affected.
7. Lubricate grease fittings on brush housings until
grease purges past inboard seals. Wipe excess grease
from seals and fittings.
CAUTION
Contact with the reel, bedknife or other cutting
unit parts can result in personal injury. Use
heavy gloves when handling the cutting reel.
Reelmaster 7000
1
3
1. Drive pulley
2. Driven pulley
2
1. Rear roller brush
2. Rear roller
Page 8 - - 39
CHECK
ALIGNMENT
2
Figure 48
3. Straight edge
1
3
Figure 49
3. Light contact
DPA Cutting Units