Cutting Unit Removal And Installation - Toro Reelmaster 7000 Service Manual

Cutting Unit Removal and Installation

Cutting Unit Removal
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. If front outside cutting units (#4 or #5 cutting unit) is
being removed, separate hydraulic hoses from hose
guide.
3. Remove hydraulic reel motor from cutting unit that is
to be removed (see Hydraulic Reel Motor Removal in
this section). Position motor away from cutting unit.
4. Remove snapper pin from cutting unit chain bracket
and lift arm chain (Fig. 17).
5. Remove cutting unit from lift arm pivot yoke (Fig. 16):
A. Remove lynch pin that retains carrier frame to
pivot yoke in lift arm.
B. Remove carrier frame shaft from pivot yoke on lift
arm.
6. Move cutting unit away from machine.
Cutting Unit Installation
IMPORTANT: When installing cutting unit to ma-
chine, make sure that turf compensator spring is
mounted on the same side of the cutting unit as the
hydraulic reel drive motor. Also, make sure that cut-
ting unit is installed on machine with motor and
weight properly orientated to machine (Fig. 18).
1. Position cutting unit to machine.
2. Install cutting unit to lift arm pivot yoke (Fig. 16):
A. Make sure that thrust washer is positioned on
carrier frame shaft. Coat the carrier frame shaft with
clean grease.
B. Insert the carrier frame shaft into lift arm pivot
yoke.
C. Secure cutting unit to pivot yoke with lynch pin.
3. Secure lift arm chain to cutting unit chain bracket with
snapper pin (Fig. 17).
4. Install reel motor to cutting unit (see Hydraulic Reel
Motor Installation in this section).
5. If front outside cutting unit (#4 or #5 cutting unit) was
removed, install hydraulic hoses into hose guide.
Reelmaster 7000
4
1
1. Carrier frame
2. Lynch pin
1. Lift arm chain
2. Chain bracket
1
4
2
FRONT
1
1. Reel motor location
Page 8 - - 15
2
Figure 16
3. Pivot yoke
4. Thrust washer
2
3
Figure 17
3. Snapper pin
1
2 2
1
3
2
Figure 18
2. Weight location
DPA Cutting Units
3
1
1
5
1