Toro Reelmaster 7000 Service Manual page 281

8. If reels stall or become erratic while backlapping, in-
crease the engine speed slightly until the reel speed sta-
bilizes.
9. To make an adjustment to the cutting units while
backlapping, disengage the PTO switch and turn the en-
gine OFF. Wait for all machine movement to stop. After
adjustments have been completed, repeat steps 5
through 8.
10.When the backlapping operation is completed, dis-
engage the PTO switch and turn the engine OFF. Wait
for all machine movement to stop. Run a file across the
front face of the bedknife (Fig. 21). This will remove any
burrs or rough edges that may have built up on the cut-
ting edge. Repeat procedure on all cutting units.
11. When done backlapping, return the mow control
manifold backlap levers to the F (mow) position, lower
and secure operator seat. Wash all lapping compound
from cutting units. Adjust cutting unit reel to bedknife as
needed.
NOTE: If the backlap lever is not returned to the F
(mow) position after backlapping, the cutting units will
not function properly.
Reelmaster 7000
Relief Angle
Page 8 - - 17
Top Face
Remove
Burr
Front
Face
Front Angle
Figure 21
DPA Cutting Units