Service And Repairs; Service And Repairs; Brake Assembly - Toro Reelmaster 7000 Service Manual

Service and Repairs

Brake Assembly

19
18
17
15
RIGHT
FRONT
75 to 85 ft- -lb
(102 to 115 N- -m)
1. Flange head screw (6 per planetary)
2. Splined brake shaft
3. Planetary assembly (2 used)
4. Front wheel assembly (2 used)
5. Lug nut (8 per wheel)
6. Retaining ring
7. Spring plate
CAUTION
When changing attachments, tires or perform-
ing other service, use correct blocks, hoists and
jacks to raise and support machine. Make sure
machine is parked on a solid level surface such
as a concrete floor. Prior to raising machine, re-
move any attachments that may interfere with
the safe and proper raising of the machine. Al-
ways chock or block wheels. Use appropriate
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
Axles, Planetaries and Brakes
17
16
14
13
12
11
10
19
8. Compression spring
9. Jam nut
10. LH Brake assembly
11. Flange head screw (4 per brake)
12. Hex plug
13. Piston motor (2 used)
14. Flat washer (2 per motor)
75 to 85 ft- -lb
(102 to 115 N- -m)
1
6
2
20
8
7
9
4
Figure 1
Brake Assembly Removal (Fig. 1)
1. Park machine on a level surface and raise cutting
units to allow easier access to front brake assembly.
Stop engine, engage parking brake and remove key
from the ignition switch.
2. Drain oil from planetary wheel drive/brake assembly.
3. Chock rear wheels and jack up front of machine (see
Jacking Instructions in Chapter 1 -- Safety). Support ma-
chine with appropriate jack stands.
4. Remove wheel assembly.
Page 6 - - 4
85 to 100 ft- -lb
3
(116 to 135 N- -m)
15. Cap screw (2 per motor)
16. O- -ring
17. O- -ring
18. RH brake assembly
19. Gasket
20. Brake cable (LH shown)
Reelmaster 7000
5