Put on the cutted gear housing and fix it in place with 4 nuts (Figure 2.9.5.5)
Tightening the pinion shaft nut:
NOTE
Tightening instructions:
Use tool no. 20 (Figure 2.9.5.4)
Pre-tightening: 30 Nm (22 ft-lb) + 60° angle of rotation
Loosening
Final tightening: 30 Nm (22 ft-lb) + 60° angle of rotation
Tighten the pinion shaft retaining frame with 11 nuts using a crisscross pattern
Porsche spare part No.:
900.817.002.02
Torque:
33 Nm (24.3 ft-lb)
Adhesive:
Loctite 243
The four-point bearing is now centered.
Version: 16.12.2014
The counter torque wrench no. 27 touches the cutted
gear housing and thus fixes the pinion shaft in place.
(Figure 2.9.5.5)
Powertrain
2.9.5.4
2.9.5.4
911 GT3 Cup (991)
MY 2015
95