The illustration shows the saw line on the right outside.
Cut through the carrier frame at the line (1) using the electric saw (saw blade 14).
Starting from the center of the oval cutout, carry out the separation cut directly
behind the two threads.
Heat glued joints along the pierced rivets using a heat gun.
The illustration shows the left side, with the arrow pointing in the direction of travel.
Drill out the three rivets (1).
Do not drill into the carrier.
Separate the sheet's glued joints using a separating chisel. Where necessary, heat
the glued joint using a hot air blower.
Version: 16.12.2014
Bodywork
4.15.1.5
4.15.1.6
911 GT3 Cup (991)
MY 2015
207