Replace Record - E-Mu XL-7 Command Station Owner's Manual

Replace Record

Record LED
Solid - - - - Erasing Data
Flashing - - Rec. Armed
66 E-MU Systems
Replace record is a new realtime record mode that selectively overwrites
track data upon recording new data over it.
Press and hold Tap and press the Record button when in real-time record
mode. "REC+" in the display changes to read "REPL", indicating that you
are now in Replace Record mode.
T
01 REPL
Quan: 16
REC+
- - - - - - - - - - - - - - New data is added to the existing track data.
REPL
- - - - - - - - - - - - - - New data overwrites exiting track data.
Replace record works differently depending on whether the first-note
record status is on or off. See the chart below.
Mode First Note Record On
Start Point Data will be replaced from
(Punch In) the moment you play any
sort of MIDI event that the
sequencer records; note,
controller data, etc.
End Point
Data will be erased until the earlier of the following:
(Punch Out)
A: The pattern reaches the loop point (patterns) or end
point (songs). At this point, the transport automatically
punches out (unless no data was played, see next row).
B: You punch out, either by pressing STOP or REC.
If No Data is The transport stays in
Recorded "record armed" mode until
During a data is played, even over
Loop the loop point. If you
punch out before recording
anything, no data is erased.
Playing The sequencer plays exist-
Existing ing notes in the track until
Data the first data is played.
Indicates Replace Record
Ln:04 Bar: 01:1
Met: off CntIn:
First Note Record Off
Data will be erased (and
replaced) anytime its start
time is passed while replace
record is active.
If you don't play any data
during a pass, the record
mode will stay active over the
loop. If you manually punch
out without recording any-
thing, data that was in the
region of recording will be
erased. Once you play data,
the next loop point will auto-
matically punch out.
The sequencer will not play
any data on the track to be
recorded.
Sequencer
Pattern Mode