E-Mu XL-7 Command Station Owner's Manual page 74

O O O O
You can go in and out of
Record mode at any time by
pressing the Record button
O O O O
To Quick-Erase a Track:
Press and Hold the Erase button,
then press the Track button you
want to erase.
O O O O
To Erase an Entire
Pattern: Copy an "Empty
Sequence" over the pattern.
(Save/Copy menu).
O O O O
To Quick-Select a Track:
1. Press and hold Tap.
2. Press the Track Enable/Mute
button corresponding to the
track you wish to select.
62 E-MU Systems
Press the Preset View button again after you've selected a preset. The
9.
LED will go out and you'll be returned to the Pattern screen.
Get ready to record the first track!
Press Play to begin recording. Recording will begin after the count-in
10.
period (if any). The pattern will loop when it reaches the end of its
length.
Press Stop when you're finished recording.
11.
Are you happy with your performance? If not, you can erase the track and
try again.
To Erase the Track
Press the Pattern Edit button and turn the data entry control until you
12.
find the "Cut Track to Clipboard" screen.
Move the cursor to the lower line of the display under Track 1.
13.
Press the flashing Enter button to erase the track.
14.
Press the Pattern Edit button again to exit the menu, then go back to
15.
step 10 and re-record the track.
To Erase Specific Notes
Press the Erase button in Realtime Record mode and hold down the
16.
keyboard note you wish to erase. The note will be erased when it
comes around in the pattern.
To Record another Track
Press the +Track button located to the left of the LCD. The track
17.
number increments to Track 02.
Press the Preset View button. Notice that the MIDI channel has also
18.
incremented to C02A. Select a preset.
Press the Preset View button again after you've selected a preset. You'll
19.
be returned to the Pattern screen.
Press the Stop button to return the beginning of the pattern.
20.
Press Record, then Play to begin recording on track 2.
21.
After recording track 2, check out the Track Enable buttons to mute
22.
and un-mute the tracks.
A pattern must be SAVED or it will be erased when you power down or
23.
record another pattern. See "Save Pattern" on page 287.
You can continue to add up to 16 tracks. If you need more than this,
keep in mind that you can add up to 16 channels of data to each track!
Normally, it's simpler to use just one channel per track.
• To setup a track for multichannel playback see "Channel Assign" on
page 96.
Sequencer
Pattern Mode