Compaq ProLiant 6000 Maintenance And Service Manual page 93

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
3-76 Diagnostic Tools
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Network
IP address
Network
IP net
mask
Network
IP router
address
If you configure the server to boot into Compaq Utilities, the server prepares for remote
communications, so you can remotely run Diagnostics software, Inspect Utility, or System
Configuration Utility using a workstation running terminal emulation software, such as
Compaq Insight Manager or PC Anywhere.
Booting into the Operating System
When you enable ASR-2 to restart into the operating system and a critical error occurs,
ASR-2 logs the error in the Critical Error Log and restarts the server. The system ROM
pages the designated administrator, and executes the normal restart process.
IMPORTANT: When you enable ASR-2 to restart into the operating
system, Modem Dial-In Status, Network Status, and Modem Dial-Out
Status are automatically disabled. In this mode, ASR-2 can page you if a
critical error occurs, but you cannot access the server, and the server
cannot dial out to a remote workstation.
During the recovery process, the ASR-2 feature tries to restart the server up to 10 times. If
the ASR-2 feature cannot restart the server within 10 attempts, it logs a critical error in the
Critical Error Log, restarts the server into the Compaq Utilities, and puts the modem into
auto-answer mode.
Pager Setting
Data
Continued
Enter the IP address for this server in standard dot notation.
NOTE: This is not used if you select Custom for Network
controller. You must enter your IP address in the NET. CFG
file that you load into the system partition.
Enter the net mask for this server in standard dot notation.
NOTE: This is not used if you select Custom for network
controller. You must enter your IP address in the NET. CFG
file that you load into the system partition.
Enter the router to be used for this server in standard dot
notation.
NOTE: This is not used if you select Custom for network
controller. You must enter your IP address in the NET. CFG
file that you load into the system partition.
Description