Compaq ProLiant 6000 Maintenance And Service Manual page 85
Hide thumbs
Also See for ProLiant 6000:
- Management manual (41 pages) ,
- Manual (24 pages) ,
- Software manual (23 pages)
Table of Contents
Advertisement
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
3-68 Diagnostic Tools
Attended Recovery
For attended recovery, ASR-2 takes the following actions:
During system configuration, these utilities are placed on the system utilities partition of
the hard drive.
If you have configured for dial-in access and have a modem with an auto-answer feature
installed, you can dial in and remotely diagnose or reconfigure the server.
If you have configured the Compaq Utilities for network access, you can access the utilities
over the network. You can use Compaq Insight Manager for dial-in or network access.
Hardware Requirements
To use this level of ASR-2 over a modem, you need the following:
You may also run Compaq Utilities remotely over an IPX or IP network using the Network
feature:
If you are notified that ASR-2 restarted the server and you have restarted to Compaq
Utilities, use the Inspect Utility or Compaq Insight Manager to view the critical error in
the Critical Error Log. Run Diagnostics to diagnose and resolve the problem.
You can configure ASR-2 to restart the server into Compaq Utilities to diagnose the
critical error, or to start the operating system to return the server to operational status as
rapidly as possible.
Logs the error information to the Critical Error Log
Resets the server
Pages you (if a modem is present and you selected Paging)
Starts Compaq Utilities from the hard drive
Enables remote access
Compaq modem or optional Hayes modem
System Configuration Utility and Diagnostics Utility installed on the system
partition of the hard drive
ASR-2 configured to load Compaq Utilities after restart
To use Compaq Utilities on an IPX network, you must have Compaq Insight
Manager 2.0 or later or an NVT (Novell Virtual Terminal) Terminal Emulator with
VT100 or ANSI terminal capabilities.
To use Compaq Utilities on an IP network, you must have Compaq Insight Manager
2.10 or later, or a Telnet Terminal Emulator with VT100 or ANSI capabilities.
Advertisement
Table of Contents
