Compaq ProLiant 6000 Maintenance And Service Manual page 91

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .
3-74 Diagnostic Tools
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Dial-out
status
Dial-out
string
Network
status
Network
protocol
Network
controller
Network
host name
Network
card slot
Pager Setting
Data
Enabled
555-1234
Enabled
Compaq
CPQHOU
Slot #
Continued
Allows ASR-2 to dial out to a remote workstation. If you
selected this option, Dial In Status is automatically selected.
To use the dial-out feature, set Dial-Out Status to Enabled
and set the Dial-Out String to the correct phone number.
You must also set the Reset Boot option to Boot Compaq
Utilities. When the system restarts because of an ASR reset,
the administrator is paged via Pager Status and Pager Dial
String, the system restarts to the Compaq Utilities, and dials
out to the phone number provided in the Dial-Out string. The
dial-out number will be tried five times. If it fails to connect
after five attempts, the modem is put in auto-answer mode.
Enter the dial string followed by the remote computer's
telephone number.
To allow network access to Compaq Utilities, set Network
Status to Enabled and make sure the Reset Boot option is
set to Boot Compaq Utilities.
To use IPX network access, set Network Protocol to IPX.
When the system restarts to the Compaq Utilities because of
an ASR reset, it loads IPX network support. This enables
remote access via NVT.
To use IP network access, set Network protocol to IP. Also
make sure to set Network IP address, Network IP net mask,
and Network IP router address. When the system restarts to
the Compaq Utilities because of an ASR reset, it loads IP
network support. This enables remote access via Telnet.
NOTE: The Network Status must be set to Enabled for
network access.
For all Compaq Standard Network Controllers.
Enter the network name of the server. Use underscores
instead of spaces within the name, for example,
Compaq_Server. If you are using IPX network access to the
Compaq Utilities, this server name is used to advertise NVT
host services. This server name displays in the Compaq
Insight Manager server list when it determines it can
communicate via NVT. Set this name to be the same as the
server name you assign when the host OS is running.
Select the slot number of the network interface card you
wish to use for network access to Compaq Utilities.
Description