Table of Contents
Advertisement
The WGS3 LAYER 3 SWITCH can be configured through an Ethernet connection, make sure the manager PC must be set on
same the IP subnet address with the WGS3 LAYER 3 Switch. For example, if you have changed the default IP address of the
Switch to 192.168.1.1 with subnet mask 255.255.255.0 via console, then the manager PC should be set at 192.168.1.x (where
x is a number between 2 and 254) with subnet mask 255.255.255.0. Or you can use the factory default IP address
192.168.1.254 to do the relative configuration on manager PC.
Logging on the switch
1.
Use Internet Explorer 6.0 or above Web browser. Enter the factory-default IP address to access the Web interface. The
factory-default IP Address as following:
http://192.168.1.254
2.
When the following login screen appears, the system will ask you to enter the username and password.
Default User name: admin
Default Password: admin
The login screen in following jpg sceen appears.
User's Manual of WGS3-2820/WGS3-5220
4. Web Configuration
35
Advertisement
Table of Contents
