1. Insert Disk 1 of the EPSON Status Monitor 2 software in a
floppy disk drive.
2. Click START and Run .
3. Type A:\Setup (if you inserted the disk in a drive other than
drive A, substitute the appropriate letter) and click OK .
4. Follow the on-screen instructions, then click FINISH to complete
the installation procedure.
See Chapter 6 for instructions on using the EPSON Status
Monitor 2 utility.
For Windows 3.1 Users
Installing the printer driver
Follow the steps below to install the printer driver for
Windows 3.1.
1. Make sure Windows 3.1 is running and the Program Manager
window is open.
2. Insert Disk 1 of your printer driver software in a disk drive.
3. Choose Run from the File menu. The following dialog box
appears:
2-8
Setting Up Your Software