Control Panel Buttons and Lights
Font lights
Indicate which font is
selected. To select a font,
see Chapter 5.
Tear Off/Bin button
•
Feeds continuous
paper backward to
the tear-off position.
•
Advances continuous
paper from the tear-off
position to the
top-of-form position.
•
Selects a cut-sheet
feeder bin when the
cut-sheet feeder is
installed.
Tear Off/Bin light
•
Flashes when
continuous paper is in
the tear-off position.
•
On when bin 1 of the
optional cut-sheet
feeder is selected.
•
Off when bin 2 of the
optional cut-sheet
feeder is selected.
Micro Adjust
Using the micro adjust
feature, you can press the
7
and
buttons to adjust the
top-of-form or tear-off
position. See Chapter 3.
LF/FF button
•
Feeds paper line by
line.
•
Ejects a single sheet
or advances
continuous paper to
the next top-of-form
position when held
down.
Paper Out light
•
On when no paper is loaded in
,
the selected paper source or
paper is not loaded correctly.
•
Flashes when paper has not
been fully ejected or a paper
jam has occurred.
Load/Eject button
•
Loads a single sheet
of paper.
•
Ejects a single sheet
of paper if a sheet is
loaded.
•
Loads continuous
paper from the
standby position.
•
Feeds continuous
paper backward to
the standby position.
Operate button
Turns the printer on
and off. The printer
is off when the top
of this button is even
with the button
protectors.
Pause button
•
Stops printing
temporarily, and
resumes printing
when pressed again.
•
When held down for
three seconds,
enters the micro
adjust mode. When
pressed again, exits
the micro adjust
mode.
Pause light
On when the printer is
paused.