The paper thickness lever is
set incorrectly.
The printer does not feed continuous paper to the standby
position.
Cause
You may not have torn off the
printed pages before pressing
the Load/Eject button.
Wrong top-of-form position
Your printing appears too high or low on the page.
Cause
The paper size setting in your
application software or
printer driver may not match
the size of the paper you are
using.
The printer's page length
settings for the front or rear
tractor may not match the size
of the continuous paper you
are using.
8-6
Troubleshooting
Set the paper thickness lever to match
the thickness of your paper. See
"Setting the Paper Thickness Lever" in
Chapter 3.
What to do
Tear off the printed pages at the
perforation. Then press the
Load/Eject button to feed the paper
backward to the standby position.
What to do
Check the paper size setting in your
application or printer driver.
Check the page length settings for the
front or rear tractor using the printer's
default-setting mode or the EPSON
Remote! utility. See "Making Default
Settings" in Chapter 5, or "Using the
EPSON Remote! utility" in Chapter 2.