Epson FX-880 User Manual page 69

4. Slide the left sprocket approximately 12 mm (0.5 inches) from the
far left position and push the lever back to lock it in place.
Then slide the right sprocket unit to match the width of your
paper, but do not lock it. Move the paper support midway
between the two sprocket units.
12 mm (0.5 inches)
5. Make sure your paper has a clean, straight edge. Then open
the sprocket covers and fit the first four holes of the paper,
printable side down , over the tractor pins.
6. Close the sprocket covers.
7. Slide the right sprocket to remove any slack in the paper; then
lock it in place by pushing the sprocket lock down.
The triangle mark on
the top of the printer
indicates the point
furthest to the left from
which printing can begin.
Printing on Continuous Paper
3
3-15