Adjusting The Top-Of-Form Position - Epson FX-880 User Manual

Adjusting the Top-of-Form Position

If your printing appears too high or low on the page, you can
use the micro adjust feature to adjust the top-of-form position
as described in the steps below.
The top-of-form position is where the printer will start printing.
c
Caution:
Never use the knob to adjust the top-of-form position; you may
damage the printer or lose the top-of-form position.
Note:
Your top-of-form position setting remains in effect until you
change it, even if you turn off the printer.
The top margin setting made in some application software
overrides the top-of-form position setting you make with the
micro adjust feature. If necessary, adjust the top-of-form position
in your software.
1. Make sure the printer is turned on. If necessary, lift up the
printer cover so you can see the paper position.
2. Load paper. (When the tractor is in a push position, press the
Load/Eject button to load continuous paper to the current
top-of-form position.)
3. Hold down the Pause button for about three seconds. The
Pause light starts flashing and the printer enters the micro
adjust mode.
3-30
Printing on Continuous Paper