Control And Data Connections - Crs-300 To Modems In Cdm-600/600L Emulation Mode; Figure 4-14. Cabling Example For Crs-350 To Cdm-625 - Comtech EF Data CRS-300 Installation And Operation Manual

CRS-300 1:10 Redundancy Switch
Cables and Connections
The choices from this display are:
Once the desired emulation mode is selected, press the
4.5.6.2 Control and Data Connections – CRS-300 to Modems in CDM-600/600L
Emulation Mode
For each CDM-625 that replaces a CDM-600/600L modem: Refer to Figure 4-15 to connect and
secure the CA/WR Control/Data Cable cables between each CDM-625 and the CRS-300 as
follows:
•
DB-25M connector labeled "P1" on the RMI or TMI(s), to
•
DB-25F connector labeled "Data Interface" on the CDM-625.
For all system configurations and cable interconnection of the various traffic data types available for
the CDM-625 in this operational mode, refer to
CRS-300 to Modems

Figure 4-14. Cabling Example for CRS-350 to CDM-625

•
Normal: CDM-625
•
Emulate: CDM-600 , and
•
Emulate: CDM-600L .
for specific details.
(Connections shown for RMI and TMI 1 only)
ENT
button to save the configuration .
Chapter 4.5.1 Control and Data Connections –
4–36
Revision 16
MN/CRS300.IOM