Redundancy Configuration With Carrier-In-Carrier - Comtech EF Data CRS-300 Installation And Operation Manual

1:10 redundancy switch
Hide thumbs Also See for CRS-300:
Table of Contents

Advertisement

CRS-300 1:10 Redundancy Switch
Modem, RMI/TMI, and Switch Configuration
5.2.4.2.1
CDM-625 Redundancy Configuration with Carrier-in-Carrier
If Carrier-in-Carrier
configuration steps must be taken to ensure proper operation of the modem(s) within a configured
1:N Redundancy System.
Before any configurations can be made, refer to Figure 4-9 and the instructions found on Page
4-22 in Chapter 4. CABLES AND CONNECTIONS to connect and secure the PMSI Multi-
drop CnC Plus Cable CA-0000275 (<11X> DB-9M, 8.25') between the Redundant Modem and
any Traffic Modem(s) using CnC.
The CA-0000275 cable bypasses the CRS-300 1:10 Redundancy Switch.
IMPORTANT
Once all CnC-enabled modems have been interconnected with the PMSI Multi-drop Cable, the
user must then configure each CnC-enabled modem via the modem's front control panel:
From the CDM-625 top-level SELECT: menu, using the ◄► arrows and ENTER keys,
navigate each menu level until the PMSI control mode display screen appears:
SELECT: Configuration
Select: Configuration Test Monitor
Info Store/Ld Utility ODU FAST (34)
CONFIG: All Mode Tx Rx Clocks D&I
CnC EDMAC Misc Mask Remote IP (34)
Carrier-in-Carrier: Mode
Search-Delay
CnC PMSI mode: Redundancy
(Idle, Redundancy, Talk, Listen) (v)
From the PMSI mode display screen, use the
ENTER.
The Pre-Mapped Symbol Interface (PMSI) is a function associated with DoubleTalk
®
in-Carrier
that permits the modulator in a selected unit to provide a direct copy of its output (the
outbound interferer) to one or many other modems. The other modem(s) may then choose to take
the PMSI signal, and use it for its own CnC reference. The PMSI is an EIA-485 multidrop bus
system where one device transmits, and all other devices on the multi-drop bus are configured to
receive.
This configuration step must be repeated for every CnC-enabled CDM-625
within the configured redundancy system.
®
(CnC) is utilized with any CDM-625 traffic modem, special
CnC
PMSI-control
▲ ▼
5–4
PMSI-control
Freq-Offset
(34)
arrow keys to select Redundancy, then press
Revision 16
MN/CRS300.IOM
®
®
Carrier-

Advertisement

Table of Contents
loading

Table of Contents