Table of Contents
Advertisement
CRS-300 1:10 Redundancy Switch
Introduction
Data Type
EIA-422, V.35
10/100 Ethernet
Notes 5, 6
ASI
G.703 Bal (DDI, IDO, DDO, IDI)
G.703 Unbal
G.703 Bal (DDI, IDO, DDO, IDI)
G.703 Unbal (DDI, IDO, DDO, IDI)
HSSI
10/100 Ethernet
EIA-422, V.35, LVDS
G.703 Bal (DDI, IDO, DDO, IDI)
G.703 Unbal
Quad E1
Notes:
1. For CDM-600 modem to switch data (Bal and Unbal) use DB-15 to DB-15
2. For CDM-625 modem to switch data (Bal and Unbal) use DB-9 to DB-15
3. As of September 2008, the CRS-320 TMI is obsolete. Use the CRS-340
4. For CDM-625 where the terrestrial data type is Ethernet, the User can use
5. From Redundant Modem to RMI, use DB-25 to DB-25 Control cable.
6. From Traffic Modem to TMI, use DB-9 to HD-15 Control cable.
1.4.3.1 RMI Card: CDM-570/570L, -600/600L, -625
Figure 1-5.
CRS-310 RMI
(PL/9579-1)
Note 4
Note 2
Note 2
Note 2
Note 4
Note 2
Notes 1, 2
data cable.
data cable.
TMI in its place.
only one of any four Ethernet ports on the CDM-625 rear panel in Ethernet
Bridge Mode.
(2X) BNC - Male
HD-50 Female
CDM-625 Modem
TMI Type
Notes 5, 6
CRS-316
Notes 5, 6
CRS-325
CRS-330
Note 2
Notes 5, 6
CRS-336
Note 3
CRS-340
CDS-365D
DB-15 Male
1–9
Revision 16
MN/CRS300.IOM
RMI Type
CRS-310
Notes 5, 6
DB-25 Male
Advertisement
Table of Contents
