System Voice Mailbox Programming When A Pri Is Programmed; Analog Co Lines; Call Routing Facilities On T1 And T1/E1 Pri; Calling Number Routing - Mitel 3000 Administrator's Manual

System Voice Mailbox Programming when a PRI is programmed

System voice mailbox is programmed as follows:
•
From the programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "System Voice Box" is displayed.
•
Select "System Voice Box".
•
Select the lines to be answered by the System Voice mailbox. The lines that will be answered are
indicated by a "♦".
Press the speakerphone key to finish programming.
Note: If PRI is selected all the available B-channels are answered by the System Voice Mailbox. Lines
24 - 27 are the CO Lines, IP Trunks 1 - IP trunks 12 are VoIP lines.

ANALOG CO LINES

A single T1 interface providing 24 lines on T1. 23 lines on T1 PRI and 30 B channels on E1 PRI can be
equipped. However two additional Line modules can be equipped providing for up to four analogue lines
which can also be used. The maximum number of line interfaces that can be provided is 28 on T1 (24 lines
and 4 CO lines), 27 on T1 PRI (23 B channels and 4 CO lines) and 34 on E1 PRI (30 B Channels and 4 CO
lines).
The line modules are installed in the two network card slots on the CCU.
CALL ROUTING FACILITIES ON T1 AND T1/E1
PRI
Calls can be routed to extensions or groups based on the Calling number (CLID or ANI) or the called
number (DID or DNIS).
Two programmable tables are provided. The CID/ANI Table (Calling Number) and the DID/DNIS Table
(Called Number).
The CID / ANI table provides 200 entries and the DID/DNIS table provides 100 entries.
Note: The CID/ANI table is the current 'CID Programming' option with the number of entries increased
from 100 to 200.
In both these tables the number can be associated with a name. The routing of a call is also programmed.
The call can be routed to a group or an extension. Courtesy service or Auto Attendant can also be selected.

CALLING NUMBER ROUTING

Calls can be routed to extensions or groups based on CLI or ANI information received from the network.
If the number received matches an entry in the CID/ANI Table (200 entries) the call is routed to the
programmed extension or group. If the received number does not match an entry in the list, the call is
presented to the group or extension programmed for the T1 line, or the PRI interface, in the Incoming
Ringing programming. This is Group 1 in default.
If a name is associated with the number in the CID/ANI Table the name is presented to the extension or
extensions programmed to ring.
•
From the programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
131
Mitel 3000
Administrator's Manual