Caller Id Detection; Programming Dial Tone Detection; Programming Long Co Line; Line Name - Mitel 3000 Administrator's Manual

Mitel 3000
Administrator's Manual

Caller ID Detection

Note: For this feature to operate, it also needs to be enabled by your network provider. Programming Caller
ID Detection
On standard CO lines on the Mitel 3000, the "Caller ID Detection" option is programmed. The system can
then detect when Caller ID information is being sent from the network and display the number.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "PSTN Programming" is displayed.
•
Select "PSTN Programming".
•
Press the Scroll Down key ( ) until "Caller ID Detection" is displayed.
Select "Caller ID Detection" The lines with "Caller ID Detection" programmed are indicated with a "♦".
Press the speakerphone key to finish programming.
Note: For this feature to operate Caller ID needs to be enabled by your telephone company.

Programming Dial Tone Detection

When a CO line is selected to make a call the system detects the dial tone on the line before it sends the
digits. You can change this operation so that dial tone detection is turned off and the system will send digits
to line as they are dialed. When dialtone detection is set on, and no dial tone is present on the line, the
display will show "Line disconnected" if an attempt is made to select the line.
If dial tone detection is turned off the line will be connected and digits dialled whether dial tone is present
or not.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "PSTN Programming" is displayed.
•
Select "PSTN Programming".
•
Press the Scroll Down key ( ) until "Disable Dialtone Detect" is displayed.
•
Select "Dialtone Detection" The lines with "Dialtone Detection" programmed are indicated with a
"♦".
Press the speakerphone key to finish programming.

Programming Long CO Line

This programming option allows the line impedance on the switch CO circuit to be adjusted. The Long
CO line is the normal setting for standard business lines connected to the system. The alternative setting
should be chosen in cases where the line impedance is resistive impedance. This is likely to be the case if
the Lines being used are extension circuits off a parent PABX or an analog port on an ISDN T/A.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "PSTN Programming" is displayed.
•
Select "PSTN Programming".
•
Press the Scroll Down key ( ) until "Long CO Line" is displayed.
The Lines with Long CO line programmed are indicated with a "♦".
Press the speakerphone key to finish programming.

Line Name

Please refer to page 103.
114