Using The Function Keys; Dss Extensions; Backlit Display; Data Port - Mitel 3000 Administrator's Manual

Using the Function Keys

There are four function keys located directly above the Feature Phone display. Particular features are
grouped under these keys, as follows:
H
H
Hold
This key is used to place calls on system hold. When calls are placed on hold using this
key, a prompt "Return To Line" is presented on the display.
This key accesses the options available to customize your Feature Phone settings. It also
accesses System Programming from the programming extension only. (See page 30 for customizing your
Feature Phone and page 31 for System Programming access).
This key accesses voice mail and Display Messaging features. (See page 60 for Voice
Mail and page 77 for Display Messaging). To access voice mail, the Voice Mail Module must be installed.
This key allows you to program and dial numbers in the System and Personal Speed-Dial
lists, and also allows convenient dialing of the telephone number. (See page 36 for Speed-Dial Lists).

DSS Extensions

Up to eight of the sixteen key Feature Phone can be equipped with a DSS.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Extensions".
•
Press the Scroll Down key ( ) until "DSS Extensions" is shown.
•
Select "DSS Extensions".
•
Select those extensions which are to be equipped with a DSS.
An AC adapter is connected to the sixteen key Feature Phone to supply the additional power needed for the
32 extra keys.

Backlit Display

The sixteen key Feature Phone can be backlit. The AC adapter must be used to backlight the display.

Data Port

A connector marked "Data Port" is provided on the left-hand side of the Feature Phone. It is designed to
allow modems to be connected in parallel with the phones. Although you can connect telephone sets to the
port their operation is limited. Calls can be made and answered. However it is not possible to transfer calls
from a phone connected to the dataport.
If a call is made or answered from a phone connected to the dataport you can go off hook on the Feature
Phone and continue the call from it. If you do this then the call can be transferred etc., from the Feature
Phone.
When a call is made from a device connected to the data port the number dialed and the status of the call is
indicated on the systemphone.
29
Mitel 3000
Administrator's Manual