Programming A Rolling Code System; Programming An Entrance Gate/All Devices In The Canadian Market - Lexus GX470 2006 Service Manual

Programming a rolling code system

If your device is "Rolling Code" equipped, it is necessary
to follow steps 1 through 4 under the heading
R
"Programming the HomeLink " before proceeding with
the steps listed below.
1. Locate the "training" button on the ceiling mounted garage
door opener motor. The exact location and color of the button
may vary by brand of garage door opener. Refer to the owner's
guide supplied by the garage door opener manufacturer for the
location of this "training" button.
2. Press the "training" button on the ceiling mounted garage
door opener motor.
Following this step, you have 30 seconds in which to initiate
step 3 below.
3. Press and release the vehicle's programmed HomeLink
button twice. The garage door may open. If the door does
open, the programming process is complete. If the door does
not open, press and release the button a third time. This third
press and release will complete the programming process by
opening the garage door.
The ceiling mounted garage door opener motor should now
R
recognize the HomeLink unit and be able to activate the
garage door up/down.
4. Repeat steps 1 through 3 for each remaining HomeLink
button to program another rolling code system.
Programming an entrance gate/programming
all devices in the Canadian market
1. Decide which of the 3 HomeLink
program.
2. Place your hand held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Press and hold the selected HomeLink
4. Continuously press and release (cycle) the hand held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
slow to a rapid flash after 20 seconds, you can release both
R
buttons.
6. Test the operation of the HomeLink
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
button to program another device.
R
I n f o r ma t i o n P r o v i d e d b y :
INTERIOR EQUIPMENT
R
buttons you want to
R
.
R
in view while
R
button.
R
changes from a
R
by pressing the newly
R
87