Table of Contents
Advertisement
STARTING AND DRIVING
The height control indicator light indicates which mode is
selected. (See "(e) Height control indicator light" described
below.)
D Selecting the "HI" mode
Push the height select switch on the "Y" side when the vehicle
speed is under about 30 km/h (19 mph).
To change the "N" mode to "HI": Push the switch once.
To change the "LO" mode to "HI": Push the switch twice. It
takes about 30 seconds until the "LO" mode changes to the "HI"
mode.
D Selecting the "N" mode
To change the "HI" mode to "N": Push the height select
switch on the "B" side once.
To change the "LO" mode to "N": Push the height select
switch on the "Y" side once.
D Selecting the "LO" mode
Push the height select switch on the "B" side while the vehicle
is stopped.
To change the "N" mode to "LO": Push the switch once.
To change the "HI" mode to "LO": Push the switch twice.
Even if the engine is stopped while the vehicle height is being
lowered, the operation continues for up to 25 seconds. If within
this 25 seconds, any of the side doors or the back door is
opened, operation will continue for a further 15 seconds.
368
D If the vehicle height is changed frequently when the
vehicle is heavily loaded, the compressor may
overheat causing the vehicle height adjustment
operation to stop.
D Before you lower the vehicle height with the height
select switch, check under the vehicle to make sure
nothing to damage the vehicle or no one to be injured
is there and that the underbody of the vehicle does
not touch the ground.
D After unloading, the height of a vehicle equipped with
the rear height control air suspension becomes
slightly higher than the normal vehicle height. Take
sufficient care where the overhead height is
restricted.
D Do not select the "LO" mode in the bumpy roads. If
the underbody of the vehicle touches the rugged
road surface, the vehicle may be damaged.
I n f o r ma t i o n P r o v i d e d b y :
NOTICE
Advertisement
Table of Contents
