Table of Contents
Advertisement
Trailer lights
Your vehicle is equipped with a wire harness stored in the rear
end underbody. Use either of them to connect and operate the
trailer lights. However, the trailer lights must comply with
federal, state/provincial and local regulations. See your local
recreational vehicle dealer or rental agency for the correct type
of wiring and relays for your trailer. Check for correct operation
of the turn signals and stop lights each time you hitch up. Direct
splicing may damage your vehicle's electrical system and
cause a malfunction of your lights.
Break in schedule
Lexus recommends that you do not tow a trailer with a new
vehicle or a vehicle with any new power train component
(engine, transmission, differential, wheel bearing, etc.) for the
first 800 km (500 miles) of driving.
Maintenance
D If you tow a trailer, your vehicle will require more frequent
maintenance due to the additional load.
information, please refer to the scheduled maintenance
information in the "Owner's Manual Supplement/Scheduled
Maintenance".
D Retighten all fixing bolts of the towing ball and bracket after
approximately 1000 km (600 miles) of trailer driving.
Connecting a trailer
Stop your vehicle and a trailer in line and perform the following:
1. Put the rear height control air suspension in the "LO" (low)
mode. Turn the ignition switch off or push the "HEIGHT
CONTROL OFF" switch to turn off the rear height control air
suspension.
2. Connect a trailer.
3. Turn the ignition switch on or push the "HEIGHT CONTROL
OFF" switch to turn on the rear height control air suspension.
Select the "N" (normal) mode with the height select switch.
Disconnecting a trailer
Stop your vehicle and a trailer in line and perform the following:
1. Put the rear height control air suspension in the "LO" (low)
mode. (Make sure the vehicle height is in the "LO" (low) mode
by pushing the height select switch on the "B" side.)
2. Turn the ignition switch off or push the "HEIGHT CONTROL
OFF" switch to turn off the rear height control air suspension.
For this
3. Set the supporting leg of a trailer on the ground and raise the
hitch by 100 mm (4 in.).
4. Turn the ignition switch on or push the "HEIGHT CONTROL
OFF" switch to turn on the rear height control air suspension.
I n f o r ma t i o n P r o v i d e d b y :
DRIVING TIPS
413
Advertisement
Table of Contents
