Table of Contents
Advertisement
STARTING AND DRIVING
For vehicles sold in Canada
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this de-
vice must accept any interference, including interference
that may cause undesired operation of the device.
392
Replacing tires and wheels
When replacing the wheels, be sure to install air pressure
sensors on the wheels.
There are 3 ways to set up the air pressure sensors:
(a) Remove the sensor from the old wheel and install it to the
new wheel.
(b) Keep the same wheel with air pressure sensor and replace
only the tire.
(c) Use a new wheel and sensor.
You have to register an ID code for a new sensor. Up to 2 sets
of codes can be registered. As one ID for the originally installed
sensor is registered at "MAIN" of the selector switch, use the
"2nd" position to register an ID for the new sensor.
You do not need to re register the ID code for any other
replacements. For the use of the originally installed tires, put
the selector switch at "MAIN" and for the use of tires set
purchased later, put the switch at "2nd". For the sensor
selector switch, see page 393.
I n f o r ma t i o n P r o v i d e d b y :
Advertisement
Table of Contents
