Table of Contents
Advertisement
STARTING AND DRIVING
HOW TO START THE ENGINE
Cranking hold function
Once you turn the ignition key to "START" position and release
it, the cranking hold function continues to crank the engine in
"ON" position until it starts.
The function stops cranking the engine after about 25 seconds
maximum if the engine has not started yet. When you crank
the engine again, wait a few seconds and restart it.
If you hold the key in "START" position, the function will keep
cranking for about 30 seconds maximum.
Before cranking
1. Apply the parking brake firmly.
2. Turn off unnecessary lights and accessories.
3. Put the selector lever in "P". If you need to restart the engine
while the vehicle is moving, put the selector lever in "N". A
starter safety device will prevent the starter from operating if
the selector lever is in any drive position.
4. Depress the brake pedal and hold it to the floor until driving
off.
348
Starting the engine
Before starting the engine, be sure to follow the instructions in
"Before cranking".
Normal starting procedure
The multiport fuel injection system/sequential multiport fuel
injection system in your engine automatically controls the
proper air fuel mixture for starting. You can start a cold or hot
engine as follows:
With your foot off the accelerator pedal, turn the ignition key to
"START" position, then release it.
Engine should be warmed up by driving, not in idle. For
warming up, drive with smoothly turning engine until engine
coolant temperature is within normal range.
If the engine stalls...
Simply restart it, using the correct procedure given in normal
starting.
If the engine will not start...
See "If your vehicle will not start" on page 426.
D Do not race a cold engine.
D If the engine becomes difficult to start or stalls
frequently, have the engine checked immediately.
I n f o r ma t i o n P r o v i d e d b y :
NOTICE
Advertisement
Table of Contents
