Wan Failover - LevelOne AMG-2100 User Manual

3.4.1 WAN Failover

Configure WAN Failover:
Go to: System >> WAN Traffic.
Enable WAN Failover: Normally AMG-2100/AMG-2101 uses WAN1 as it primary WAN interface.
When WAN Failover is enabled and WAN2 is available, WAN1's traffic will be routed to WAN2 when
WAN1 connection is down. On the other hand, a Service Zone's policy could also use WAN2 as its
interface; in that case, if WAN2 is down, the WAN2's traffic under its policy will also be routed to
WAN1.
Fall back to WAN1 when WAN1 is available again: If WAN Failover is enabled, the traffic will
be routed to WAN2 automatically when WAN1 connection fails. When fall back to WAN1 is
enabled, the routed traffic will be connected back to WAN1 when WAN1 connection is recovered.
AMG-2100 Gigabit Access and AP Management Gateway/
AMG-2101 Gigabit Access and AP Management Gateway Plus
25
User's Manual