Discovery Ap - LevelOne AMG-2100 User Manual

5.3 Discovery AP

Configure Discovery AP, go to: Access Points >> Discovery.
After AP template configuration is finish, use this function to detect and manage all of the APs in the
network segments. Note that AMG-2100/AMG-2101 can only manage APs that are connected to its LAN
ports. Therefore, the AP discovery function is for adding locally connected APs to its management list.
The administrator must know the local IP addresses of the APs he/she wishes to discover. Or the better
way is reset the AP to default setting for discovery.
To discover AP:
AP Type: Choose the type of AP you wish to discover.
Interface: Set to default.
Admin Settings Used to Discover: Choose from Factory Default or Manual, if the AP is
not using the default IP.
Then click the Scan Now button and the APs match the given settings will show in the list below. If one
of the IP addresses intended is used, a warning message will show up. In this case, please change the
IP range and then click Scan Now again.
AMG-2100 Gigabit Access and AP Management Gateway/
AMG-2101 Gigabit Access and AP Management Gateway Plus
73
User's Manual