Table of Contents
Advertisement
3.4.1 WAN Failover
Configure WAN Failover:
Go to: System >> WAN Traffic.
Enable WAN Failover: Normally AMG-2001 uses WAN1 as it primary WAN interface. When WAN
Failover is enabled and WAN2 is available, WAN1's traffic will be routed to WAN2 when WAN1
connection is down. On the other hand, a Service Zone's policy could also use WAN2 as its interface;
in that case, if WAN2 is down, the WAN2's traffic under its policy will also be routed to WAN1.
Fall back to WAN1 when WAN1 is available again: If WAN Failover is enabled, the traffic will
be routed to WAN2 automatically when WAN1 connection fails. When fall back to WAN1 is
enabled, the routed traffic will be connected back to WAN1 when WAN1 connection is recovered.
AMG-2001
Access and AP Management Gateway
24
User's Manual
Advertisement
Table of Contents
