Table of Contents
Advertisement
2.3 Hardware Description
2.3.1 Front Panel
1.
LED Indicators: There are three kinds of LED, Power, Status and Hard-disk, to indicate
different status of the system.
2.
Mgmt: For management use only, it always will open WMI (Web Management Interface)
homepage.
3.
WAN1/ WAN2: Two WAN ports (10/100/1000 Base-T RJ-45) are connected to the external
network, such as the ADSL Router from your ISP (Internet Service Provider).
4.
LAN1/ LAN2: Client machines connect to AMG-2100/AMG-2101 via these LAN ports
(10/100/1000 Base-T RJ-45).
5.
Reset:
Press and hold the Reset button for about 5 seconds and status of LED on front panel will start
to blink before restarting the system.
Press and hold the Reset button for more than 10 seconds and status of LED on the front panel
will start to speed up blinking before resetting the system to default configuration.
6.
Console: The system can be configured via a serial console port. The administrator can use a
terminal emulation program such as Microsoft's Hyper Terminal to login to the configuration
console interface to change admin password or monitor system status, etc.
Note:
By default, all LAN ports are set with Port-based Default Service Zone; for Service Zone
configuration, please refer to 3.3 What is Service Zone.
AMG-2100
Gigabit Access and AP Management Gateway/
AMG-2101
Gigabit Access and AP Management Gateway Plus
9
User's Manual
Advertisement
Table of Contents
