Hardware Installation - LevelOne WHG-1000 Quick Installation Manual

Hardware Installation

Please follow the steps mentioned below to install the hardware of WHG-1000:
1. Place the WHG-1000 at a best location.
The best location for WHG-1000 is usually at the center of your wireless network.
2. Connect WHG-1000 to your outbound network device.
Connect one end of the Ethernet cable to the WAN port of WHG-1000 on the front
panel. Depending on the type of internet service provided by your ISP, connect the
other end of the cable to the ATU-Router of an ADSL, a cable modem, a switch or a
hub. The WAN LED indicator should be ON to indicate a proper connection.
3. Connect WHG-1000 to your network device.
Connect one end of the Ethernet cable to the LAN1 port of WHG-1000 on the front
panel. Connect the other end of the cable to a PC for configuring the system. The
LAN1 LED indicator should be ON to indicate a proper connection.
Note:
WHG-1000 has two virtual zones Private and Public which are mapped to
LAN1(192.168.1.254) and LAN2(192.168.11.254) respectively.
4. There are two ways to supply power over to WHG-1000.
Connect the DC power adapter to the WHG-1000 power socket on the front
(a)
panel.
Caution:
Please only use the power adapter supplied with the WHG-1000 package.
Using a different power adapter may damage this system.
WHG-1000 is capable of transmitting DC current via its WAN PoE port. Connect
(b)
an IEEE 802.3af-compliant PSE device, e.g. a PoE-switch, to the WAN port of
WHG-1000 with the Ethernet cable.
Now, the hardware installation is completed.
Caution:
To double verify the wired connection between WHG-1000 and your
switch/router/hub, please check the LED status indication of these network
devices.
6