Hardware Installation - LevelOne WHG-1000 Quick Installation Manual

2. Hardware Installation

Please follow the steps mentioned below to install the hardware of WHG-1000
1. Place the WHG-1000 at a best location.
The best location for WHG-1000 is usually at the center of your wireless network.
2. Connect WHG-1000 to your outbound network device.
Connect one end of the Ethernet cable to the WAN1/WAN2 port of WHG-1000 on the front panel. On your
environment, connect the other end of the cable to the external Internet . The WAN1/WAN2 LED indicator
should be ON to indicate a proper connection.
3. Connect WHG-1000 to your network device.
Connect one end of the Ethernet cable to LAN port of WHG-1000 on the front panel. Connect the other end of
cable to a PC for configuring the system. The LAN LED indicator should be ON to indicate a proper
connection.
4. There are two ways to supply power over to WHG-1000
 Connect the DC power adapter to the WHG-1000 power socket on the front panel.
Please only use the power adapter supplied with the WHG-1000 package. Using a
different power adapter may damage this system
 WHG-1000 is capable of transmitting DC current via its LAN(PoE) port. Connect an IEEE 802.3af-
compliant PSE device, e.g. A PoE Switch, to the LAN(PoE) port of WHG-1000 with the Ethernet
cable.
Now, the hardware installation is completed.
To double verify the wired connection between WHG-1000 and your switch/router/hub,
please check the LED status indication of these network devices.
300Mbps Wireless PoE Hotspot Gateway
WHG-1000
6
Quick Installation Guide