81131_7.book Page 78 Wednesday, March 17, 2004 3:59 PM
78
•
SeaTalk interface
If you have connected the ST4000+ to other SeaTalk instruments or
control units, check the links as follows:
1. Press standby.
2. Select display lighting level 3 (LAMP 3) on any other SeaTalk
instrument or control unit.
3. The ST4000+ should immediately respond by switching on its
display lighting:
•
ST4000+ Wheel & Tiller Autopilots: Owner's Handbook
if the ST4000+ is not receiving wind data, it will display a
NO DATA message: check the wind instrument and
connections
LAMP
if the display lighting does not switch on, there is a fault in the
SeaTalk cabling between the ST4000+ and the other
instruments/control units
D3565-2
D5336-1