81131_7.book Page 55 Wednesday, March 17, 2004 3:59 PM
Chapter 5: Installing the ST4000+
'B'
90 degrees
Cantilever mounting
If you need to attach the tiller drive to a vertical face (such as the
cockpit sidewall), use a Raymarine cantilever socket assembly
(part number D031):
•
the maximum possible extension offset is 254 mm (10 in)
•
you cut the cantilever to the exact length during mounting
Cutting the cantilever rod to length
1. Clamp the tiller on the boat's center line.
2. Measure dimension F (actual).
3. Refer to the table to establish a cutting length for the cantilever
rod – double check measurements before cutting.
4. Measure the rod from threaded end, then cut the cantilever rod
to length L using a hacksaw. Remove any sharp edges with a file.
Dimension F
686 mm (27 in)
711 mm (28 in)
737 mm (29 in)
762 mm (30 in)
787 mm (31 in)
813 mm (32 in)
838 mm (33 in)
D309-2
Cut length L
51 mm (2 in)
75 mm (3 in)
102 mm (4 in)
127 mm (5 in)
152 mm (6 in)
178 mm (7 in)
203 mm (8 in)
55