Raymarine ST4000+ Owner's Handbook Manual page 67

81131_7.book Page 59 Wednesday, March 17, 2004 3:59 PM
Chapter 5: Installing the ST4000+
Brown
Installing the socket
1. Apply the template (supplied at the rear of this handbook) to the
bulkhead.
2. Carefully drill a 18 mm (
3
( / in) pilot holes. Remove the template.
32
3. Pass the cable through the bulkhead and attach to the socket,
making sure you connect each core to the correct pin (as shown).
Rear of socket
Drive (blue)
3 stripe terminal
To the
control unit
4. Attach the socket to the bulkhead using the two self-tapping
screws. Use cable clamps to secure the drive cable at regular
intervals.
23
/ in) clearance hole and two 2.5 mm
32
Terminal
identification
stripes
Drive (brown)
2 stripe terminal
59
Blue
D3284-2
D383-5